Plastering leveling mortar C-39

Plastering leveling mortar C-39 high-quality plaster mortar for leveling walls for facing work

APPLICATION

Plaster solution is used for leveling walls, ceilings, and also as a plaster solution. Thanks to special additives, the solution is highly plastic, has a high adhesion to almost any surface, does not form cracks.

PREPARATION OF THE SURFACE

Preparation of the base is carried out according ДБН В.2-22-2001. The surface of the wall on which the plaster solution is applied should be pre-cleaned of grease, old paints, plaster exfoliations, loose substrates. All the grounds must be treated with a primer of deep penetration of trademark ARTISAN “No. 7”, or “No. 8”, depending on the absorbency of the substrate. Bases that have traces of biological corrosion should be treated with antiseptic “Antifungus 14”. For very smooth bases it is recommended to use “Concrete contact” of the TM “Artisan”.

PERFORMANCE OF WORK

To obtain a solution, it is necessary to pour a dry mixture into the water and mix thoroughly by mechanical means until a homogeneous paste-like composition is obtained. Allow the solution to stand for 5 minutes, stir again. The resulting solution is applied to the prepared surface with a thickness of no more than 20 mm. With a total thickness of the plaster layer more than 25-35 mm. it is necessary to use a construction net as a reinforcing element.

All recommendations are valid at a temperature of +20 ° C and a relative humidity of 60%.

! Under adverse weather conditions (high temperature, dry wind, direct sunlight), the time of use of the solution applied to the surface can be significantly reduced.

! When the temperature of use of the solution decreases, the setting time increases.

When carrying out work should be guided by building codes and regulations. The manufacturer is not liable for improper use of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

The mixture contains cement, which, when mixed with water, forms an alkali. Work should be in rubber gloves. If the solution gets into the skin or eyes, rinse them with plenty of water, if necessary, consult a doctor.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 25 kg.

TECHNICAL CHARACTERISTICS

Composition: Mixture of cement with mineral fillers and special additives

The amount of water for mixing: 5,5-5,9 l /25 kg

Time of use, min, not less than: 120

Application temperature, ° С: from +10 to +30

Strength of adhesion to the substrate, MPa, not less than: 0.3

Compressive strength, MPa, not less than: 7.5

Frost resistance, cycles, not less than: 50

Water vapor permeability mg / m * h * Pa: 0.13

Consumption, kg / m² / mm, not more than:  1.5

APPLIES WITH LAYER 5-20 MM

VAPOR- PERMEABLE

CONVENIENT IN APPLICATION

WATERPROOF

FROST-RESISTANT

ENVIRONMENTALLY PURE

 

Mixture “Artisan”  Ц.1.ШТ2

ДСТУ БВ.2.7-126:2011

Hygienic conclusion of the Ministry of Health of Ukraine.