Primer paint F6

Primer paint F6 white primer increases adhesion to the basics of thin-layer plasters and facade paints

APPLICATION

Priming paint is designed for pre-treatment of bases as a strengthening, adhesive primer before applying subsequent textured, decorative coatings. It is applied on the bases of concrete, cement-sand, cement-lime plasters, bricks, plasterboard, etc. inside and outside buildings. It is also used in the system of external warming by wet method “Artisan” before applying decorative plaster. Can be used as an independent decorative layer. The primed base has the appearance of a white rough surface.

PREPARATION OF THE SURFACE

Preparation of the base is carried out, according to СНиП 3.04.01-87  and ДБН В.2.6-22-2001. The substrate must be dry, clean, without visible damage. Loose, unstable, porous surfaces are removed mechanically, aligned.

PERFORMANCE OF WORK

Stir well before use. The paint should be applied to the surface with a paint brush (do not apply with a roller). The work should be carried out at the temperature of the base from +5 to +30 ºС. Under normal climatic conditions (temperature +20 ° C and relative humidity 60%), the drying time is 4 hours. During application, as well as drying, freshly painted surfaces must be protected from rain, strong wind and direct sunlight until completely dry. Immediately after use, the instruments should be rinsed thoroughly with water, if necessary, cleaned with an organic solvent.

ATTENTION! Do not freeze the product. The manufacturer is not responsible for the incorrect use of the material, as well as for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

Do not apply primer paint to skin and mucous surfaces. It is advisable to work in rubber gloves. In case of contact with skin or eyes, rinse thoroughly with water.

EXPIRATION DATE

In original hermetic packaging and in cool conditions (not below +5 ° C and not above +30 ° C) 12 months from the date of manufacture indicated on the package. Avoid freezing.

PACKAGING

The paint is packed in plastic buckets of 7.5 and 15 kg.

UTILIZATION

Unused residues should be allowed to dry and disposed of with household rubbish.

TECHNICAL CHARACTERISTICS

Composition: mixture of pigments and fillers in aqueous polymer dispersions

Drying time, hour.: from 3 to 6

Appearance of the painted surface: matt milky white

Density :  1,58 – 1,65 kg / l

Application temperature :  from +5 °С to +30 °С

Consumption, kg / m2 : 0,35  – 0,4

POLYMER

STRENGTHENS WEAK SURFACES

INCREASES ADHESION TO VARIOUS BASES

HIGH COATING CAPACITY

VAPOR-PERMEABLE

WATERPROOF

ECOLOGICALY CLEAN

ТУ У В.2.7-24.3–30554583-004-2002

Hygienic conclusion of the Ministry of Health of Ukraine.