Adhesive heat-retaining mixture C-18

APPLICATION

The mixture is used for gluing ceramic, stone (except marble slabs for which, taking into account the nature of the material, white glue is used) of the tiles on strong non-deformable substrates. It is especially recommended to use in facing fireplaces, stoves and warm floors.

A specific feature of the mixture is its increased thermal insulation properties, which allow increasing the heat-storage properties of fireplaces, stoves and warm floors. The product is resistant to vertical surface and has a good correction time, increased plasticity in comparison with standard adhesives. Improved technological properties of the mortar allow it to be used in mosaic tiles and tiles. If necessary, a variant of the glue is white.

PREPARATION OF THE SURFACE

Preparation of the base is carried out in accordance with SNiP 3.04.01-87 and DBN B.2.6-22-2001. The substrate should be smooth, dry, durable, free from grease, old paints and other materials that reduce adhesion. The substrate must be primed with primer # 7 or, if necessary, with primer # 8 of the trade mark “Artisan” before application of the mortar mixture.

PERFORMANCE OF WORK

! Do not wet the tiles.

The dry mixture is mixed manually or mechanically with clean water until a uniform consistency is obtained. Stir the mixture for 3-5 minutes, then mix again. The mortar mixture is applied to the prepared base with the even side of the notched trowel, then the tooth side is spread over the surface. At a time, such an amount of mortar is applied to glue the tiles in 20 minutes.

The tiles are laid on the mortar and easily pressed against the base. Under normal climatic conditions, after 48 hours the surface is ready for technological displacement, you can fill the seams with a fugue.

NOTE. Warming of the lined base is done after the full strength of the adhesive solution and the casing. Raise the temperature of the base gradually. The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

Avoid contact with the skin and mucous membranes. Be sure to work in rubber gloves. In case of contact with the skin and eyes, rinse thoroughly with running water.

 

 

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 20 kg.

TECHNICAL CHARACTERISTICS

Composition: a mixture of white cement with mineral fillers and special additives

Quantity of water for solution preparation, l / kg :  0,28 – 0,32

Time of use, hours, not less than: 2

Open time, min, not less than:  20

Correction time, hours, not less than:  10

Strength of adhesion to the base, MPa, not less than: 0,5

Application temperature, ° С: +5 to +30

Operating temperature, ºС:  to +100

Maximum layer thickness, mm: 10

Consumption, kg / m2 / mm: 1,2

Coefficient of thermal conductivity, W / m K:  0,3

 

– EASY TO USE  

– HIGHLY PLASTIC

– SUSTAINABLE ON VERTICAL PLANES

– THERMAL INSULATING

– HIGH ADHESION

– WATERPROOF

– ENVIRONMENTALLY FRIENDLY 

 

Mixture “Artisan” C.2.ZK1

DSTU BV.2.7-126: 2011

Hygienic conclusion of the Ministry of Health of Ukraine