Adhesive mixture for internal works – for fixing ceramic tiles indoors
For fixing ceramic tiles indoors
The mixture is used for gluing ceramic or stone tiles, no larger than 30 x 30 cm indoors.
PREPARATION OF THE SURFACE
The substrate should be smooth, dry, durable, free from grease, old paints and other materials that reduce adhesion. The loose rather weak layer must be removed. The treat the surface before applying the mortar with primer No. 7 or, if necessary, with primer No. 8 of the trade mark “Artisan”.
PERFORMANCE OF WORK
! Do not wet the tiles.
The dry mixture is mixed manually or mechanically with clean water until a uniform consistency is obtained. Stir the mixture for 3-5 minutes, then mix again. The mortar mixture is applied to the prepared base with the even side of the notched trowel, then the tooth side is spread over the surface. At a time, such an amount of mortar is applied to glue the tiles in 20 minutes. The tiles are laid on the mortar and easily pressed against the base. Within 10 minutes you can adjust the position of the tiles.
After 48 hours, the surface is ready for technological displacement; you can fill the seams with a fugue. The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for by the instruction.
The mixture contains cement, which when combined with water forms alkali. It is necessary to prevent the hitting impregnation on the skin and mucous membranes. All work should be carried out in goggles, rubber gloves and protective clothing. Provide fresh air. In case of contact with skin or eyes, rinse thoroughly with water and if necessary, consult a doctor.
In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.
The dry mix is packaged in bags of 25 kg.
Composition: a mixture of white cement with mineral fillers and special additives
Quantity of water for solution preparation, l / kg : 0,16-0,18
Time of use, min, not less than: 60
Open time, min, not less than: 20
Correction time, min, not less than: 10
Strength of adhesion to the base, MPa, not less than: 0,5
Temperature of use, ° С: from +10 to +30
Maximum layer thickness, mm: 10
Consumption, kg / m2 / mm: from 2 to 4,5
LAYER THICKNESS 2-10 mm
RESISTANT ON VERTICAL SURFACES
CONVENIENT IN APPLICATION
Mixture “Artisan” C.1.RSH1
DSTU B В.2.7-126: 2011
Hygienic conclusion of the Ministry of Health of Ukraine