Adhesive mixture for outside works C-12

APPLICATION

The mixture is used for gluing ceramic or stone tiles inside or outside of wall or floor buildings: clinker tiles, glass mosaic, as well as tiles made from natural or artificial granite (or other products having a minimum water absorption) onto non-deformable substrates such as concrete, brick, plaster.

Due to the increased adhesion, the mixture is recommended for laying tiles on an old ceramic surface, on the remains of old glue or mineral solutions. It can also be used for stone or block masonry with thin seams. Tiles of large dimensions should be fastened to the base, in accordance with SNiP 3.04.01-87.

PREPARATION OF THE SURFACE

The substrate should be smooth, dry, durable, free from grease, old paints and other materials that reduce adhesion. Loose, rather weak layer must be removed. Base before applying the mortar mixture to treat with primer No. 7 or, if necessary, with primer  No. 8 of the trade mark “Artisan”.

PERFORMANCE OF WORK

!! Do not wet the tiles.

The dry mixture is mixed manually or mechanically with clean water until a uniform consistency is obtained. Leave the mixture for 3-5 minutes, then mix again. The solution is applied to the prepared

The base with a flat side of the notched trowel, then the tooth side is spread over the surface. At a time such an amount of solution is applied, so that in 20 minutes you can have time to glue the tile. The tiles are laid on the mortar and easily pressed against the base. Within 10 minutes you can adjust the position of the tiles.

After 48 hours, the surface is ready for technological displacement, you can fill the seams with a fugue. When carrying out construction work should be guided by the current building rules and regulations.

! Under adverse weather conditions (high temperature, wind, direct sunlight, etc.), the time of use of the solution deposited on the surface can be significantly reduced.

! When the temperature of use of the mixture decreases, the setting time of the adhesive increases. The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

The mixture contains cement, which when combined with water forms alkali. It is necessary to prevent the hitting impregnation on the skin and mucous membranes. All work should be carried out in goggles, rubber gloves and protective clothing. In case of contact with skin or eyes, rinse thoroughly with water and if necessary, consult a doctor.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 25 kg.

TECHNICAL CHARACTERISTICS

Composition: a mixture of white cement with mineral fillers and special additives

Quantity of water for solution preparation, l / kg :  0,22 – 0,24

Time of use, min, not less than: 60

Open time, min, not less than: 20

Correction time, min, not less than: 10

Strength of adhesion to the base, MPa, not less than: 0,8

Temperature of use, ° С: from +10 to +30

Consumption, kg / m2 / mm: from 2 to 4,5

 

LAYER THICKNESS 2 – 10 mm

VERY HIGH ADHESION

RESISTANT TO VERTICAL SURFACES

DOES NOT HAVE SHRINKAGE

PERFECT FOR OLD CERAMIC SURFACES

CONVENIENT IN APPLICATION

HIGHLY PLASTIC

DO NOT BURN

FROST-RESISTANT

WATERPROOF

ENVORINMENTALLY FRIENDLY

 

Mixture “Artisan” C.1.ZK2

DSTU BV.2.7-126: 2011

Hygienic conclusion of the Ministry of Health of Ukraine