Adhesive mixture for tile warming C-13

APPLICATION

The mixture is used for all facade warming systems with an “easy wet” method for gluing insulation boards (expanded polystyrene and mineral wool). The mixture is elastic, has good adhesion to the base and heat insulation plates.

PREPARATION OF THE SURFACE

The substrate should be smooth, dry, durable, free from grease, old paints and other materials that reduce adhesion. Loose, weak layer must be removed. The substrate must be primed with primer No. 7 or, if necessary, with primer No. 8 of Artisan trademark before application of the mortar mixture.

PERFORMANCE OF WORK

The dry mixture is mixed manually or mechanically with clean water until a uniform consistency is obtained. Leave the mixture for 3-5 minutes, then mix again. The solution can then be used for about 2 hours.

For gluing the plates, the prepared mortar mixture is applied along the perimeter of the plates with a strip (width 4-5 cm). In the center of the plate is formed 6-8 spots, a height of at least 1 cm and a diameter of about 10 cm.  The solution should not fall on the end plates, the excess solution must be removed. To make a reinforcing layer of plaster it is necessary to proceed 72 hours after gluing the plates. All recommendations are valid at a temperature of 20 ° C and a relative humidity of 60%. In the production of works should be guided by the current building codes and regulations.

The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

The mixture contains cement, which when combined with water forms alkali. Avoid contact with the skin and mucous membranes. Be sure to work in rubber gloves. In case of contact with the skin and eyes, rinse thoroughly with water.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 25 kg.

 

TECHNICAL CHARACTERISTICS

Composition: a mixture of white cement with mineral fillers and special additives

Quantity of water for solution preparation, l / kg :  0,19-0,22

Time of use, min, not less than: 120

Correction time, min, not less than: 10

Strength of adhesion to the base, MPa, not less than: 0,5

Temperature of use, ° С: from +5 to +30

Consumption, kg / m2 : from 4  to 6

 

– HIGH ADHESION

– SUSTAINABLE ON VERTICAL PLANES

– EASY TO USE  

– HIGHLY PLASTIC

– FROST RESISTANT

-STEAM PENETRATIVE 

– ENVIRONMENTALLY FRIENDLY 

 

Mixture “Artisan” C.1.3K5

DSTU BV.2.7-126: 2011

Hygienic conclusion of the Ministry of Health of Ukraine