Adhesive white mixture C-19

APPLICATION

The mixture is used for gluing boards from light marble, natural stone, mosaic, and also plates with high water absorption to non-deformable substrates (cement plaster, concrete, monolithic cement floor). Can be used for gluing ceramic tiles. Resistant to weathering, waterproof, frost-resistant.

PREPARATION OF THE SURFACE

The substrate should be smooth, dry, durable, free from grease, old paints and other materials that reduce adhesion. Loose, rather weak  layer must be removed. Base before applying the mortar mixture to treat with primer No. 7 or if necessary – with primer No. 8 of the trade mark “Artisan”.

! To prevent the appearance of gray spots on light rocks of natural stone, cement plasters and concrete, on which the glue is applied, should have a residence time of at least 28 days.

PERFORMANCE OF WORK

The dry mixture is mixed manually or mechanically with clean water until a uniform consistency is obtained. Leave the mixture for 3-5 minutes, then mix again. The mortar mixture is applied to the prepared substrate with a flat side of the notched trowel with a thin layer, then the tooth side is spread over the surface. At a time, such an amount of mortar is applied to glue the tiles in 20 minutes. Do not pre-wet the tiles. The tiles are laid on the mortar and easily pressed against the base. Within 10 minutes you can adjust the position of the tiles.

!! When gluing thin marble tiles, it should be remembered that they can slightly change their color, which is caused by the high water-absorbing ability of marble. This effect disappears after the solution dries completely (after about 7 days).

After 48 hours, the surface is ready for technological displacement, you can fill the seams with a fugue. When carrying out construction work, it is necessary to be guided by the current building codes and rules.

!! Under adverse weather conditions (high temperature, wind, direct sunlight, etc.), the time of use of the solution deposited on the surface can be significantly reduced.

!! With a decrease in the temperature of use of the mixture, the setting time of the adhesive increases. The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for in the instruction.

 

 

SAFETY PRECAUTIONS

The mixture contains cement, which when combined with water forms alkali. Avoid contact with the skin and mucous membranes. Be sure to work in rubber gloves. In case of contact with the skin and eyes, rinse thoroughly with water.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

Packaging

The dry mix is packaged in bags of 25 kg.

TECHNICAL CHARACTERISTICS

Composition: a mixture of white cement with mineral fillers and special additives

Quantity of water for solution preparation, l / kg :  0,21 – 0,23

Time of use, min, not less than: 60

Open time, min, not less than: 20

Correction time, min, not less than: 10

Strength of adhesion to the base, MPa, not less than: 1,0

Temperature of use, ° С: from +10 to +30

Consumption, kg / m2 : from 2 to 4,5

 

LAYER THICKNESS 2 – 10 mm

EXCLUDES THE APPEARANCE OF STAINS AND RIVERS

WHITE COLOR

HIGHLY PLASTIC

DO NOT BURN

FROST-RESISTANT

WATERPROOF

ENVORINMENTALLY FRIENDLY

 

Mixture “Artisan” C.1.ZK2

DSTU B В.2.7-126: 2011 Hygienic conclusion of the Ministry of Health of Ukraine