GYPSUM PLASTER OF MECHANICAL APPLICATIONS GS-75

GYPSUM PLASTER OF MECHANICAL APPLICATIONS GS-75 for mechanical plastering of the walls and ceilings

Category:

GYPSUM PLASTER OF MECHANICAL APPLICATIONS GS-75 for mechanical plastering of the walls and ceilings

APPLICATION

Plaster “Mechanics” is used for plastering walls and ceilings with interior decoration of premises. It is applied to all standard mineral substrates either manually or mechanically.

PREPARATION OF THE SURFACE

The surface should be dry and durable, free from grease, old paints, crumbling plaster. To ensure high-quality and long-term exploitation, it is recommended to prime all grounds with primer  “Artisan No. 7” , or “Artisan No. 8 Super”, depending on the requirements to the substrate.

PERFORMANCE OF WORK

When plaster is applied mechanically, the dry mix is mixed with water in the installation, in a continuous automatic mode. The water supply to the plaster station should be adjusted in accordance with the consistency. Apply the plaster by spraying and leveling. In the event of a break in operation for more than 15 minutes, the machine should be cleaned with water. The hardened solution can only be removed mechanically. The average layer thickness is 15 mm (min 10 mm). Plastering in two layers is allowed. At the end of the work, immediately flush the tool and the plaster station.

The manufacturer is not responsible for misuse of the material and its application in the manner and conditions other than those specified in these instructions.

SAFETY PRECAUTIONS

All components that make up the mixture are non-toxic and harmless to health. Work with the material in accordance with accepted standards.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 30 kg.

TECHNICAL CHARACTERISTICS

Composition: mixture of gypsum, mineral fillers and special additives

Amount of mixing water for manual application method, l / kg:  0,35 – 0,45

Time of use of the solution for manual application, mm, not less than:  60

Time of use, min, not less than: 60

Optimum temperature for solution use, ° С: from +5 to +30

Maximum layer thickness per application, mm:  30

Compressive strength, MPa, not less than:  2,0

Consumption for layer thickness 10 mm, kg / m2:  9-10

Thickness of a layer in one pass:

  • min-10 mm
  • -30 mm

Drying: in 7 days

Rotor-stator (PFT): D6-3

Water consumption:  650 l./hour

Hose Diameter:  25 mm.

MAXIMUM LAYER THICKNESS 30 MM

HIGH-PLASTIC

WHITE SMOOTH SURFACE

EASY TO USE

DOES NOT BURN

ENVIRONMENTALLY PURE

Mixture “Artisan”  Г.2.ШТ6

ДСТУ БВ.2.7-126:2011         

Hygienic conclusion of the Ministry of Health of Ukraine.

Reviews

There are no reviews yet.

Be the first to review “GYPSUM PLASTER OF MECHANICAL APPLICATIONS GS-75”

Your email address will not be published. Required fields are marked *