Glue for gypsum plasterboard GS-62

Glue for gypsum plasterboard GS-62

APPLICATION

Glue GS-62 is used for gluing to the solid bases of gypsum boards, combined gypsum panels. It can also be used for gluing stucco molding, gypsum blocks.

PREPARATION OF THE SURFACE

The surface of the wall on which the plaster solution is applied should be pre-cleaned of grease, old paints, plaster exfoliation, loose substrates. All the grounds must be treated with the primer “ARTISAN No. 7” or “ARTISAN No. 8”, depending on the substrate. With ground unevenness of more than 2 cm, the surface is leveled using gypsum boards (10 cm wide), which are glued to the GS-62 glue.

PERFORMANCE OF WORK

To obtain a solution, the dry mixture is poured into a container of water, at room temperature, thoroughly mixed until a uniform composition and the desired consistency are obtained and after 5 minutes it is re-mixed. Work with the solution should be with a clean tool made of stainless steel or plastic. Do not wet the base! If the surface is flat or leveled by means of strips, the solution is applied to the sheets of gypsum board with a notched trowel with continuous longitudinal strips and along the perimeter. At unevennesses of more than 2 cm, the HS-62 glue is applied with flat cakes along the edge of the gypsum board with an interval of 35 cm and along the perimeter with a minimum interval (almost complete). The installed panel is tightly pressed to the base and with light shocks through the rail is set according to the level. All recommendations are valid at a temperature of + 20 ° C and a relative humidity of 60%.

When carrying out work should be guided by building codes and regulations.

The manufacturer is not responsible for misuse of the material and its application in the manner and conditions other than those specified in these instructions.

SAFETY PRECAUTIONS

All components that make up the mixture are non-toxic and harmless to health. Work with the material in accordance with accepted standards.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 15 and 30 kg.

TECHNICAL CHARACTERISTICS

Composition: mixture of gypsum, mineral fillers and special additives

Amount of water for mixing the mortar, l / kg: 0,34 – 0,43

Time of use: at t 20 ° C – 30 minutes

Temperature of use:  from +10 to +30

Peel strength, MPa, not less than:  0,5

Consumption, kg / m² / mm, up to:  1,2

MAXIMUM LAYER THICKNESS 30 MM

HIGH-PLASTIC

WHITE SMOOTH SURFACE

EASY TO USE

DOES NOT BURN

ENVIRONMENTALLY PURE

 

Mixture “Artisan”  Г.2.3К6

ДСТУ БВ.2.7-126:2011         

Hygienic conclusion of the Ministry of Health of Ukraine.