CEMENT- LIME PLASTER FOR MACHINE APPLICATION C-57

CEMENT- LIME PLASTER FOR MACHINE APPLICATION C-57

CEMENT- LIME PLASTER FOR MACHINE APPLICATION C-57

APPLICATION

The mixture is intended for machine / as well as manual / plastering of brick (from ceramic, silicate, concrete bricks), concrete (including lightweight concrete), cement, cement-lime, lime-sand bases, 5-20 mm layer inside and out buildings, as well as in rooms with high humidity. Can be used as a base for decorative plasters and paint coatings.

PREPARATION OF THE SURFACE

The substrate must be smooth, dry, strong, and free from dust, dirt, grease, paint and other materials that reduce adhesion. The crumbling layers must be removed. All the grounds need to be pre-treated with the primer number 7 or, if necessary, primer number 8 or primer number 15 of trademark “Artisan”.

PERFORMANCE OF WORK

For machine application, the water supply must be adjusted in accordance with the required consistency. With a properly selected consistency, the mixture will gently blend during application. Apply the mixture with a spray and level with a metal strip or similar tool. A multi-layer application of the plaster mixture is allowed, but in one pass the thickness of its layer should not exceed 20 mm. The subsequent layer is applied after the beginning of setting the previous / approximately 24 hours after application. When manually applied, the mixture is poured into water at room temperature and mixed mechanically until a uniform composition is obtained. The consistency of the mixture is controlled by the amount of water. The final surface treatment is carried out after the beginning of its setting, approximately 3-4 hours after application, depending on the substrate and weather conditions. The surface is moistened with a spongy grater. Smoothing can be done with a metal spatula, grater or other tool. In order to avoid the occurrence of defects, the applied plaster layer should be protected from rain, strong wind, drafts, direct sunlight. The room in which the work is done, it must be ventilated.

The manufacturer is not responsible for misuse of the material and its application in the manner and conditions other than those specified in these instructions.

SAFETY PRECAUTIONS

The mixture contains cement and lime, when it is watered, it forms alkali. Work should be in rubber gloves. If the solution gets on the skin or eyes, they should be rinsed with plenty of water, if necessary, consult a doctor.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 30 kg.

TECHNICAL CHARACTERISTICS

Composition: mixture of cement and lime with mineral aggregates, perlite and special additives

Maximum particle size, mm:  1,2

Temperature of use:  from +10 to +25

Compressive strength, MPa, not less than:  7,0

Strength of adhesion to the substrate, MPa, not less than:  0,3

Consumption of the mixture, kg / m2 / mm: 1,35

APPLIES WITH LAYER 5-20 MM

HYDROPHOBIZED

VAPOR- PERMEABLE

FROST-RESISTANT

EASY TO USE

ENVIRONMENTALLY PURE

Mixture “Artisan”  Ц.1.ШТ2

ДСТУ Б В.2.7-126:2011

Hygienic conclusion of the Ministry of Health of Ukraine.

 

Reviews

There are no reviews yet.

Be the first to review “CEMENT- LIME PLASTER FOR MACHINE APPLICATION C-57”

Your email address will not be published. Required fields are marked *