DECORATIVE HEAT-INSULATING PLASTERING MIXTURE FOR EXTERNAL AND INTERNAL WORKS C-52

DECORATIVE HEAT-INSULATING PLASTERING MIXTURE FOR EXTERNAL AND INTERNAL WORKS C-52

DECORATIVE HEAT-INSULATING PLASTERING MIXTURE FOR EXTERNAL AND INTERNAL WORKS C-52

APPLICATION

The mixture is intended for manual and machine plastering of any mineral surfaces: brick, stone, concrete, pumice, gypsum plaster, foam concrete inside and outside buildings. After drying, the surface can be treated with any vapor-permeable paints.

PREPARATION OF THE SURFACE

The substrate must be smooth, dry, strong, free from dust, dirt, grease, paint and other materials that reduce adhesion. The crumbling layers must be removed, if necessary, the base is pre-treated with primer No. 7, earth No. 8 super or primer No. 15 (Betonkontakt) of the trade mark “Artisan”.

PREPARATION OF THE MORTAR

For manual application.

The bag of the mixture is completely poured into a working container with water and thoroughly mixed until a uniform composition is obtained; the consistency of the mixture is adjusted to the necessary by addition of water. Do not violate the specified procedure for preparing the mortar mixture. Otherwise, a solution with other properties, including adhesion, heat-insulating, strength, etc., will be obtained. Mixing of the dry mixture with water must be carried out with a mixer at low speed for 5 minutes.

PERFORMANCE OF WORK

Screed strip are mounted on the surface to be treated. The mortar is applied manually with a stainless steel tool or with a plastering machine. After applying, the excess mixture is removed through screed strips with special tools. The maximum layer in one pass is 25 mm. If necessary, you can apply a layer of greater thickness by re-plastering the surface. After setting the mixture, screed strips are removed and their place is filled with the solution mixture. Depending on the weather and the surrounding conditions, the treated surface can be painted with paint after 2-4 days.

The manufacturer is not responsible for the misuse of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

The mixture contains cement and lime, when it is watered, it forms alkali. Work should be in rubber gloves. If the solution gets on the skin or eyes, they should be rinsed with plenty of water, if necessary, consult a doctor.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 10 kg.

TECHNICAL CHARACTERISTICS

Composition: mixture of cement, lime, light fillers and corrective additives

Temperature of use:  from +5 to +30

Bulk density, kg / m3, not more than: 430

Approximate water flow per 10 kg: 7,2-7,7 l

Time of use of a mortar mixture, min, not less than: 60

Compressive strength, MPa, not less than:  3,5

Strength of adhesion to the substrate, MPa, not less than: 0,5

Coefficient of thermal conductivity, W / mK, not more than:  0,09

Consumption of the mixture, kg / m2 / mm: 0,45

WHITE COLOR

MAXIMUM LAYER THICKNESS FOR ONE PASS 25 MM

VAPOR- PERMEABLE

FROST-RESISTANT

ENVIRONMENTALLY PURE

 

Mixture “Artisan”  Ц.1.ШТ5

ДСТУ БВ.2.7-126:2011

Hygienic conclusion of the Ministry of Health of Ukraine.

Reviews

There are no reviews yet.

Be the first to review “DECORATIVE HEAT-INSULATING PLASTERING MIXTURE FOR EXTERNAL AND INTERNAL WORKS C-52”

Your email address will not be published. Required fields are marked *