The glue is used as a masonry mortar for blocks with the correct geometric shape from lightweight concrete, without reducing their heat-insulating properties and does not create “cold bridges”.
PREPARATION OF THE SURFACE
The surface of the blocks should be cleaned of grease, old paints, dust and other materials that reduce adhesion, and treated with a primer of deep penetration of “Primer No. 8” trademark “Artisan”, or moistened.
PERFORMANCE OF WORK
The dry mixture is poured into water and thoroughly mixed for 5 minutes mechanically until a uniform composition is obtained.
After 5 minutes, repeat the mixing. The resulting solution is applied in a thin layer on the surface of the blocks, blocks are applied to the applied layer of the mortar mixture and are rubbed against the masonry. The manufacturer is not responsible for the incorrect use of the material, nor for its use for purposes and conditions not provided for in this manual.
The mixture contains cement, which, when mixed with water, forms an alkali. Work should be in rubber gloves. If the solution gets into the skin or eyes, rinse them with plenty of water, if necessary, consult a doctor.
In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.
The dry mix is packaged in bags of 25 kg.
Composition: a mixture of cement with mineral fillers and special additives.
Mixture suitability time, min, not less than: 120
Application temperature, ° С: from +10 to +25
Compressive strength limit, MPa, not less than: 5,0
Strength of adhesion to the base, MPa, not less than: 0,2
Water consumption, l / kg, approx.: 0,23 – 0,28
Consumption of the mixture, kg / m2 / mm, no more than: 1,0-1,5
THICKNESS OF THE LAYER AT THE STACKING OF BLOCKS FROM 3 MM
DOES NOT IMPAIR THERMAL INSULATING PROPERTIES OF THE WALL
Mixture “Artisan” C.1.MP1
DSTU B В.2.7-126: 2011
Hygienic conclusion of the Ministry of Health of Ukraine