Mineral plaster С 30 + Perlit

Mineral plaster С 30 + Perlit –  universal plaster for interior and exterior works

Mineral plaster С 30 + Perlit –  universal plaster for interior and exterior works

APPLICATION

Universal solution is used for construction and repair works as leveling plaster for seams between panels, walls, slits, openings, etc. It is successfully applied for leveling walls, ceilings, and also as a plaster solution. Thanks to special additives, the solution is highly plastic, has a high adhesion to almost any surface, and does not form cracks. Has a high thermal insulation quality.

PREPARATION OF THE SURFACE

The surface of the wall on which the plaster solution is applied should be pre-cleaned of grease, old paints, plaster exfoliations, loose substrates. All the grounds must be treated with a deep penetration primer TM “ARTISAN No. 7”, or primer TM “ARTISAN No. 8”, depending on the substrate.

PERFORMANCE OF WORK

To obtain the solution, it is necessary to mix 20 kg of dry product in 5.6-6.6 liters of water and mix thoroughly by mechanical means until a homogeneous paste-like composition is obtained. Allow the solution to stand for 5 minutes, and then mix again. The solution is applied to the prepared surface, with a thickness of no more than 30 mm. All recommendations are valid at a temperature of + 20 ° C and a relative humidity of 60%.

! Under adverse weather conditions (high temperature, wind, direct sunlight), the time of use of the solution which is deposited on the surface can be significantly reduced.

! When the temperature of use of the solution decreases, the setting time increases. When carrying out work should be guided by building codes and regulations.

The manufacturer is not liable for improper use of the material, nor for its use for purposes and conditions not provided for by the instruction.

SAFETY PRECAUTIONS

The mixture contains cement, which, when mixed with water, forms an alkali. Work should be in rubber gloves. If the solution gets into the skin or eyes, rinse them with plenty of water, if necessary, consult a doctor.

EXPIRATION DATE

In dry conditions and hermetic packaging the period of storage is at least 12 months from the date of manufacture.

PACKAGING

The dry mix is packaged in bags of 20 kg.

TECHNICAL CHARACTERISTICS

Composition: Mixture of cement with perlite, mineral fillers and special additives

The amount of water for mixing the solution 5.6-6.6 l / 20 kg: 5,5-6,6 l/20kg

Time of use, min, not less than: 60

Application temperature, ° С: from +10 to +30

Strength of adhesion to the substrate, MPa, not less than: 0,3

Compressive strength, MPa, not less than: 7,0

Coefficient of thermal conductivity, W / m * K, not more than: 0,3

Surface Finishing: after 48 hours

Consumption, kg / m2 / mm, not more than: 1,2

 

Mixture Artisan C.1.SHT2

DSTU BV.2.7-126: 2011

Hygienic conclusion of the Ministry of Health of Ukraine

 

 

LEVELS THE SURFACE OF CEILINGS AND WALLS (UP TO 30 MM)

LEVELING THE PANELS JOINTS

EASY TO USE

FROST-RESISTANT

DOES NOT BURN

ENVIRONMENTALLY FRIENDLY

HIGH HEAT INSULATING QUALITY

Reviews

There are no reviews yet.

Be the first to review “Mineral plaster С 30 + Perlit”

Your email address will not be published. Required fields are marked *