Primer of deep penetration CYTRYNKA EXPORT №7 for the priming of mineral surfaces, with a high content of binder polymer (developed for the EU, has a sanitary-hygienic conclusion)
Primer for deep penetration, with a high content of binder polymer, is used for the surface treatment of concrete, brick, cement-sand plaster, gypsum board, before laying parquet, ceramic tile, painting, wallpapering and plastering. To strengthen the layers prone to flowability and loosening, increase the adhesion of cellular concrete, gypsum boards, monolithic floors, hygroscopic plasters and other surfaces. The applied primer layer after drying becomes transparent, colorless, equalizes the absorbing capacity of the surface and reduces the application of paint, varnish, water dispersion and plaster compositions. Can be used as an additive in solutions to increase their plasticity, adhesion, strength and moisture resistance. It is designed for all types of work at sites, with increased sanitary and technical requirements. Do not contain solvents and plasticizers, which are the source of the release of volatile organic compounds into the environment (VOCs). Does not adversely affect the quality of air inside freshly treated rooms.
PREPARATION OF THE SURFACE
Preparation of the base is carried out, according to СНиП 3.04.01-87 and ДБН В.2.6-22-2001. The substrate must be dry, clean, without visible damage. Loose, fragile surfaces are cleaned with a brush.
PERFORMANCE OF WORK
The primer is applied to the substrate with a paintbrush, roller, etc. Fundamentals with a large absorbing capacity, it is necessary to cover 2-3 times. The manufacturer is not responsible for improper use of the material, as well as its application in order and conditions not stipulated by the instruction.
Avoid contact with skin and mucous membranes. It is advisable to work in rubber gloves. In case of contact with the skin and eyes, rinse thoroughly with running water.
In a sealed container up to 12 months. Protect from frost.
The primer is packaged in cans of 2 liters, 5 liters, 10 liters.
Composition: polymer dispersion with an increased content of water-based binders and special additives
Drying time, hour, up to: Up to 4 hours
Vapor permeability: not less than 0.05 g / m2h-Pa
Density: about 1 kg / l
Binding ability: not less than 6 g
Film resistance to static water impact: not less than 24 hours
Depth of penetration depending on substrate density: 2-4 mm
Working temperature: from +5°С to +30 °С
Consumption: from 0,1 to 0,25 l / m²
Appearance: a mixture of milk color
Stability in storage : stable
STRENGTHENS THE FOUNDATION
TRANSPARENT AFTER DRYING
HAS GOOD PERCENTAGE CAPACITY
The hygienic conclusion of the Ministry of Health of Poland НК/В/1329-1301/2015 as of 4.01.2016
You must be logged in to post a review.
There are no reviews yet.